Hi,
I see posts on this forum from 10 years ago that my current problem has been shared by others, but without any conclusive fixes.
My trusty DVR 3000 Serial No: 3302, has developed a problem. When I power the machine on at the headstock toggle switch I get the usual start screen which reads:
TEKNATOOL INT.
04.22ms 2004
then:
READY TO START AT 500rpm.
I then start the lathe running and it runs for thirty or so seconds after which the screen goes blank and it shuts down unresponsive. I switch off the power switch and even though switched off, the screen reappears after another thirty or so seconds, briefly displaying the aforementioned start screen, then goes blank after three or four seconds. At this stage I can switch on the power again and the whole sequence will repeat itself. I've also tried changing the program from NORMAL to HARD then SOFT but no difference there either.
The power supply and lead are OK and I've removed both the sheet metal covers and checked all the electrical connections are firmly plugged together, also the same for the display housing/control panel. I also blew any dust out of the headstock housing with a blower. I would greatly appreciate any advice anybody can offer.
Woodworm