Fluted Ash platter

[Valkrider]

This is my second attempt at fluting. It is 33cm in diameter and in a nicely figured piece of Ash that was quite different in hardness across the grain and as a result some of the flutes needed more sanding that others. Finished in satin acrylic lacquer. C&C welcome

[Derek]

Very nice sometimes simple pieces can be the most striking

[Mike313]

Very impressive piece of work. The detail of the fluting is crisp. I like it a lot.

[John D Smith]

Hi Colin,
             A very stunning piece of work did you use a Router set up to do the Fluting perhaps a picture of your set up would be interesting I think this is worthy of putting on the Home Page.

                                                       Regards John

[Valkrider]

Hi Colin,
             A very stunning piece of work did you use a Router set up to do the Fluting perhaps a picture of your set up would be interesting I think this is worthy of putting on the Home Page.

                                                       Regards John

John

Thanks for the comments. I posted earlier about my router setup see https://www.awgb.co.uk/awgbforum/index.php/topic,6523.0.html where there are photos.

[John D Smith]

 Thank you Colin I must have missed that nice easy Jig to make I might have a go one day.

                                                   Regards John

[Bryan Milham]

That is a stunning piece of Ash, the grain is so close and tight.

You've done it proud keeping the decoration just enough to be effective but not swamp the grain, nice work.

[Bill21]

Nice job. I really must get my router jig finished.