AWGB Woodturning Forum
General Category => Tool tips & reviews => Topic started by: Bryan Milham on May 30, 2020, 01:15:10 PM
-
I need to bore a hole, about 35mm wide by 200mm deep.
I have Forstner bit big enough but the hole is narrower than my Jacobs chuck, so I cannot bore deeper than the length of the shaft.
This is a one-off so I don't want to buy an extension bar for the Forstner bit.
Any useful ideas out there please?
-
Acces to a welder?
-
You know where I live Bryan
-
A welder, no unfortunatly
George, thank you I'll be in touch soon.