AWGB Woodturning Forum
General Category => Tool tips & reviews => Topic started by: Andy Easton on July 12, 2019, 08:36:49 AM
-
I have a record 4 jaw chuck.
Cleaned it all but when I went to re-assemble there was no numbers on the chuck body to match up the jaws .
There is only a small stug in one of the jaw recesses ,so not sure of exact sequence.
-
assuming you're talking about a scroll chuck then there will only one sequence that works when re assembled so i'd just keep going till you get it right.
-
Some chucks don't have numbers bjut dots instead. Look for some other marks like that?
Pete
-
It does not matter where you fit jaw number one as long as you fit the remaining jaws in their number sequence going clockwise.
-
If you lay your jaws out like I have and look at the first tooth they should move up the scroll(circled on each jaw) this will give the order of the jaws.
Maybe someone can explain better than I have but hopefully you get the idea
-
Hi Andy, Derek is absolutely right. If you have the pointy end of the scroll towards you; you will see that the first tooth will be closest to the point on jaw-1 and the first tooth will be farthest from the point on jaw-4 -- Julian