AWGB Woodturning Forum
General Category => Gallery => Topic started by: wider on May 13, 2019, 09:57:12 PM
-
turning over the last few days and pierced it tonight. it is 3 1/2x2 in size. all comments welcome.
-
very nice. What do you use to do the piercing
Al
-
I use the Axminister hanging motor and a 1mm carbide bit.
-
Now this looks like it was a labour of love.
But knowing your work, why have you used a piece of Yew with a crack in it. I'm sure I can see one in the base.
-
thank you for your comments and about the crack this was not there when finished and glued up but was there the next day.
-
Lovely work
Where did you get the hinge ?
-
this is the site I got the 50mm hinges from. https://www.prokraft.co.uk/BHX..html