AWGB Woodturning Forum
General Category => General Discussion => Topic started by: Thomas Lawson on August 31, 2023, 09:13:14 PM
-
Is it normal for the wood swarf from a sharp bowl gouge to get really hot, hot enough to hurt?
I have been turning very dry willow, teak, mahogany etc. and the clean shavings come off the gouge really hot.
The teak also blunted the gouge really quickly, turning what had been a clean peel of shaving to dust before resharpening
-
Prelonged use will cause friction , Friction causes heat , Yes it happens , Some wear a fingerless glove, some say it is not safe to use a glove, It is for you to decide.
-
Teak has a high silica content and that is what is blunting your gouge quickly.
-
Very dry timbers can cause a number of problems, including as you’ve found out hot shavings.
Many years ago I was asked to make something from a piece of Oak from a 400 year old building removed during a renovation. It was far too dry to turn as it was. I had previously read about soaking difficult timbers in a 50/50 solution of dish soap and water for a number of weeks (I left it for a month) and then turning it after letting it dry off for a week or two. Apart from an old cut nail hidden in the timber it turned very well all things considered.
These days I discard old very dry wood unless it’s got particularly nice grain.
-
Thanks for the replies
-
Wearing gloves while operating any form of rotating machinery is forbidden in most workplaces under H&S rules. What folks do in their own sheds is up to them. I generally only ever wear gloves for rough handling or hot work.
-
Hot shavings happen, but consider how much you may be contributing, too much pressure on the bevel = extra friction not sharpening often enough will also add to the heat. But they still happen sometimes especially on very dry wood.
I never wear gloves on the lathe except the latex type when colouring, they tear easier than skin so are probably relatively safe! But I do change my grip, often an underhand grip will keep your left hand away from the shavings.
-
Hot shavings happen, but consider how much you may be contributing, too much pressure on the bevel = extra friction not sharpening often enough will also add to the heat. But they still happen sometimes especially on very dry wood.
I never wear gloves on the lathe except the latex type when colouring, they tear easier than skin so are probably relatively safe! But I do change my grip, often an underhand grip will keep your left hand away from the shavings.
This is the best reply
Regards George