AWGB Woodturning Forum
General Category => General Discussion => Topic started by: John on July 05, 2013, 04:16:08 PM
-
Hi Guys
I am getting a lot of vibration on my Hegner. I have investigated and found a minute movement in the rear bearing.
Has anyone changed a bearing (or both) or is their any adjustment I can carry out?
If it involves a change are any special tools required?
Looking forward to your help and advice.
John
-
HI John
Yes I have changed the bearings on my Hegner when I upgraded it to a 3 pulley system. I cant remember exactly how I did it for the moment I will have to go have a look and see if I can remember it. One thing I do remember was that I needed a set of circlip pliers.
john
-
Hello John
Any pointers will be helpful
Thanks
John