AWGB Woodturning Forum
General Category => General Discussion => Topic started by: Derek on August 28, 2017, 06:50:43 PM
-
I keep looking at this bowl which is not yet finished foot still needs to be taken off and more cleaning of the edge. Would this be better to have the natural edge burnt using a pyrography machine, the wife say no but can't make up my mind. I've included a shot of the bottom just for interest
-
Hi Derek,
I like it as it is Natural and I must what a lovely piece of work However if SWMBO says leave it as it is that should be good enough, ;D what are the dimensions .
Regards John
PS when it is finished post it in the Gallery Section
-
Hi Derek,
I like it as it is Natural and I must what a lovely piece of work However if SWMBO says leave it as it is that should be good enough, ;D what are the dimensions .
Regards John
PS when it is finished post it in the Gallery Section
Thank you. I certainly will post when finished. It measures 9" X 4 3/4" but that is including the tenon so will be a little shorter when complete
-
Hi Derek
I like it just as it is in it's natural state. It does not require any enhancement - Let the wood speak for its self.
Ken
-
Look's like that would colour really well Derek :) :) :)
All the best
Ed
-
Thank you Ken and Ed.
This was just one of those I could not make up my mind on. No colour on this one Ed but I have plans on some other pieces of burr I have
-
Derek,
I think you have a whole range of options, but the one that I think would work best is something 'George' could best help you with.
He thins down a spirit stain, really thin, then applies it to the wood, it makes the grain really pop without really affecting the colour. Then lots of coats of oil, allowed to polymerise to give a good shine and your away.
-
Derek,
I think you have a whole range of options, but the one that I think would work best is something 'George' could best help you with.
He thins down a spirit stain, really thin, then applies it to the wood, it makes the grain really pop without really affecting the colour. Then lots of coats of oil, allowed to polymerise to give a good shine and your away.
I have seen this on an old video I have by Chris Stott and have tried a small piece just as an experiment. This and another method of adding colour is on the to do list for the other burrs like this that I have