AWGB Woodturning Forum

General Category => General Discussion => Topic started by: Derek on December 20, 2019, 02:45:55 PM

Title: Blowing my own trumpet
Post by: Derek on December 20, 2019, 02:45:55 PM

Not posted for a while, as well as having the flu which kept me out of the workshop. anyway a little bit of a trumpet blowing hope you don't mind. But I could not resist in this new edition of the Woodturning magazine I have been featured as Artist of the month.

Title: Re: Blowing my own trumpet
Post by: bodrighywood on December 20, 2019, 03:42:15 PM

Good for you. Look forward to seeing it and putting a face on the name at the same time.

Pete

Title: Re: Blowing my own trumpet
Post by: Derek on December 20, 2019, 03:47:02 PM

Quote from: bodrighywood on December 20, 2019, 03:42:15 PM

Good for you. Look forward to seeing it and putting a face on the name at the same time.

Pete

When you see it you wish you hadn't :o :o :o ;D ;D ;D (putting a face to a name)

Title: Re: Blowing my own trumpet
Post by: Neil Lawton on December 21, 2019, 05:22:11 PM

At least the work's pretty Derek ;D
Nicely done by the way!

Title: Re: Blowing my own trumpet
Post by: Mike313 on December 21, 2019, 05:52:31 PM

Congratulations. It must be gratifying to receive such an accolade from your peers. Very well done :)

Title: Re: Blowing my own trumpet
Post by: Les Symonds on December 21, 2019, 06:51:13 PM

Ah...I wondered if that was you. Well done and I look forward to reading it.
Les

Title: Re: Blowing my own trumpet
Post by: Derek on December 22, 2019, 01:26:36 AM

Thank you everyone.

Quote from: Neil Lawton on December 21, 2019, 05:22:11 PM

At least the work's pretty Derek ;D
Nicely done by the way!

Somene did say I could have smiled but did not want to break the camera.