Author Topic: Spiral form #2  (Read 611 times)

Offline Derek

  • platinum
  • *****
  • Posts: 1133
Spiral form #2
« on: May 21, 2019, 04:26:33 PM »
Follow on from my no-name pieces this is the other part of the spiral.

This time kept the base natural oak and turned the spiral is ebonised and then masked and painted with green interference paint. I also extended the support and added a ball, like the spiral ebonized and this time blue interference paint used.

I think I know what comments I will get with this piece also the two side by side


Offline Les Symonds

  • platinum
  • *****
  • Posts: 3104
    • Pren
Re: Spiral form #2
« Reply #1 on: May 21, 2019, 06:44:29 PM »
I liked the first one a lot.....and like the second one even more. The little sphere makes a great focal point and the base is of better proportion to the whole.
Les
Education is important, but wood turning is importanter.

Offline bodrighywood

  • platinum
  • *****
  • Posts: 3114
    • Bodrighy Wood
Re: Spiral form #2
« Reply #2 on: May 21, 2019, 07:57:58 PM »
Being realy picky, like this a lot but would prefer the pin to not show through the spiral? In at the bottom then seperately out at the top. Like I said...picky.

Pete
Turners don't make mistakes, they have design opportunities

Offline dr4g0nfly

  • platinum
  • *****
  • Posts: 4267
  • Silence is sometimes the best answer.
Re: Spiral form #2
« Reply #3 on: May 21, 2019, 09:04:34 PM »
I agree with Les with the addition of the slightly canted angle of the spiral adding a little more interest through asymmetry.

It ticks my boxes.
Oh Lord, Lead me not into temptation…

...Oh who am I kidding, follow me, I know a shortcut!

Offline Derek

  • platinum
  • *****
  • Posts: 1133
Re: Spiral form #2
« Reply #4 on: May 21, 2019, 09:23:28 PM »
Thank you Les, Pete and Bryan for the feedback on this piece.

Being realy picky, like this a lot but would prefer the pin to not show through the spiral? In at the bottom then seperately out at the top. Like I said...picky.

Pete

I don't mind picky. I did it that way as the spiral is quite thinned walled and needed the support I could always blacken that part which will help to hide it.


Offline The Bowler Hatted Turner

  • platinum
  • *****
  • Posts: 2097
Re: Spiral form #2
« Reply #5 on: May 25, 2019, 07:30:04 PM »
I like both of these very much. Well done Derek.

Offline Derek

  • platinum
  • *****
  • Posts: 1133
Re: Spiral form #2
« Reply #6 on: May 25, 2019, 10:35:44 PM »
I like both of these very much. Well done Derek.

Thank you BHT