Recent Posts

Pages: 1 ... 4 5 [6] 7 8 ... 10
51
General Discussion / Re: Woodcut bowl saver Max3 - require dimensions of missing part
« Last post by Bill21 on March 20, 2024, 03:47:37 PM »
Quote from: Mike Amphlett on March 18, 2024, 11:39:57 AM
Lumsdep,Paul's photo  looks like it was 3d printed, so you might be able to get one made for you.

Mike

I doubt it. It’s a simple turning job. Hard to tell but it could be Acetal or Nylon? If I were making a replacement I’d use Ertalyte TX or perhaps one of the lubricated Nylons like Nyloil or Ertalon.
52
General Discussion / Re: Woodcut bowl saver Max3 - require dimensions of missing part
« Last post by Dave Brookes on March 19, 2024, 09:57:32 PM »
Lumsdep,
Do you have a piece of nylon to use?  I may have a piece about 31mm dia at the length you need, or even a piece of ptfe.
Let me know although I won’t be able to send anything until next week.
Dave
53
General Discussion / Re: Woodcut bowl saver Max3 - require dimensions of missing part
« Last post by lumsdep on March 19, 2024, 08:47:58 PM »
Thanks
54
General Discussion / Re: Woodcut bowl saver Max3 - require dimensions of missing part
« Last post by Paul Hannaby on March 19, 2024, 01:15:15 PM »
Yes it turns relatively freely and isn't so tight it is bulging, it is made that shape.
55
General Discussion / Re: Woodcut bowl saver Max3 - require dimensions of missing part
« Last post by lumsdep on March 18, 2024, 09:13:59 PM »
Another quick question about the same nylon piece. When everything is bolted down is it still free to turn?
56
General Discussion / Re: Woodcut bowl saver Max3 - require dimensions of missing part
« Last post by lumsdep on March 18, 2024, 09:12:02 PM »
My plan is to get a piece of nylon or hdpe and turn it on my lathe. Probably make a test one out of wood first.
57
General Discussion / Re: Woodcut bowl saver Max3 - require dimensions of missing part
« Last post by Wood spinner on March 18, 2024, 01:54:07 PM »
Turn one using your lathe.
58
General Discussion / Re: Woodcut bowl saver Max3 - require dimensions of missing part
« Last post by Twisted Trees on March 18, 2024, 12:47:58 PM »
I think it is just a nylon guide possibly bulged at the centre by being squeezed by the retaining bolt?
59
General Discussion / Re: Woodcut bowl saver Max3 - require dimensions of missing part
« Last post by Mike Amphlett on March 18, 2024, 11:39:57 AM »
Lumsdep,Paul's photo  looks like it was 3d printed, so you might be able to get one made for you.

Mike
60
General Discussion / Re: Woodcut bowl saver Max3 - require dimensions of missing part
« Last post by lumsdep on March 17, 2024, 10:38:58 PM »
Thanks that’s exactly what l was after.

Thank you very much for your help.
Pages: 1 ... 4 5 [6] 7 8 ... 10